Gibraltar SC-RMAA Deluxe Rack Bracket

It saves space for boomstand placement on your rack tubes, to just put them on the top of a horizontal pole.
That's done with this clamp bracket.
It will save you a clamp (or 2) on your rack tube, that are also a more expensive solution than this bracket.
Especially when you want to stay within the Gibraltar shiny ecosystem.

No modification necessary, just need to remove a end cap, put this over the top and use the drum key to tighten.
Works fine.

It's not build for on and off installation because the tightening screws will leave marks on the tube, so it's better to make this a permanent modification.

There are some brands here and there offering this kind of bracket, but this one has all the necessary tube size inserts included.

Except, in my case, if you buy a complete Gibraltar rack assembly (not from Thomann) and it turns out Gibraltar kept the spare inserts for themselves when they put the assembly in the box.
That is typical Gibraltar sloppyness...and arrogance.

But well, they do make some good stuff.

In general its the perfect product for the rack pipes I am not joking...
BUT ....
I don't know if it is usual or if it is a typical Roland brand problem.
I have a rack from Roland and don't like the plastic clamps and that stuff.
However I brought in total 6 Gibralta SC RMAA brackets and all have the same problem. (no all from Thomann)

They fit so well that I was forced to use a little bit oil...put a piece of wood on the bracket and smash it with a hammer on the pipe.
That's the only negative point...but of cause now they hold everything.

So if you have no problem with this point everything is good and you should buy them they are 100x better then any plastic rack clamp.