Harley Benton Parts E-Guitar Nut 43

I bought these to swap out the white one on my Harley Benton st.
It is much better spaced than the factory ones and was a good swap after a little work on some flashing around the base.
I expect a certain amount of fettling when fitting a new nut anyway so don't think this in any way detracted from my usability of the nut.

I personally took it for myself, in order to replace it, since the previous one intentionally erased with a baritone string that did not fit.

Low price for basic quality, just as I wanted. Have a little skill and some basic tools and you'll make it work well! I'm not on board with the materials snobs who only want to use bone, or brass or whatever. If it holds the string solidly in the right position, you're going to have a good tone.

It's a plastic nut which doesn't cost much and does the job. The string spacing (not the total width) appears to be just a hair wider than the stock nuts that are standard on Asian import instruments, which is a good thing in my opinion. Gives one just a little bit more room to finger complex chords without muffling adjacent strings.
In short, a perfectly-useable guitar part hardly distinguishable from more expensive equivalents.

At this cheap, its hardly going to be amazing

But for how much it cost, i would say its pretty good!!

great replacement for the nut on my stratocaster copy that had a tuning issue

good value for money,would buy again...thanks..........

Very fragile, broke one pushing it down to nut slot with my fingers.
Good thing was i had previous nut to spare.

at that price such law quality was expected.

Very usable quality plastic nut.
Its no Graph-tech but of good quality.
good replacement part.