Millenium Headphone Holder

This is a very good product for adding any generic sort of hook or holder to a vertical bar. The clamp grabs the bar well and does not slide.

I have added it to all my mic stands and use it as a cable holder for the mic when disconnected and / or moving to corner storage.

Docking off one star for a weird design decision for the attachment mechanism. The threaded rod retracts 4cm, but the metal "J"-shaped arch only leaves room for about 1cm rods. If it would have been a half-circle "C" arch it would have fit camera tripods or monitor stands. Right now it "only" fits mic stands and sheet note stands.

You won't get metal-on-metal scratches from this to your stands. The bottom of the "J" is padded, and the end of the threaded rod has a plastic head.

None of my holders have any sharp edges, no risk off nicking any headband material.

No cons, and cheap enough to get just to test it.

I set up a small studio at home. I purchased this in the hope that I could attach it to my Mic desk boom stand. I was wrong. It is only useful on standard microphone stands. As such it is currently unused. However I will eventually get some use out of it.

It is of good construction except the mic stand It was briefly placed on, to try out, decided it didn't like it and threw it off or the holder didn't like the stand. Whichever, it doesn't bode well.

For the sake of an extra ¤2 I would recommend the Gravity holder as they are of a sturdier build & quality.