Rockboard MOD 1 V2 TRS & XLR Patchbay

Easy to install, makes for a tidy pedalboard and easy to connect various things. I use it to easily choose between one amp or two in a wet/dry setup, and to connect a volume pedal on the side of the board. Only downside is that the connections are very close together. Make sure your patchcables have slim plugs!

I think overall the product is great and a fantastic idea. However personally I would have loved an on\off switch, mostly because the power plug is tough to pull out and makes me feel like I may break the patchbay trying to schimmy the plug out. One of the other 1/4" jack inputs was really hard to push the jack through also, 1 of the 5.

Overall I think this is a good product and would recommend

This is a great item to keep your pedalboard tidy and neat. Power is handled both by a DC input/output pair and by IEC input and output sockets, which is great flexibility.

I do have one criticism though. The jack sockets are too close together to use anything except the narrowest of jack patch leads. I had to buy four more.

I am sure it works best in a Rockboard pedalboard into which it is designed to fit. However, even on my Pedaltrain board, it works well attached with pedal tape and with the front panel adaptor removed.

a good thing. very convenient for switching. but you can do without it) so think about whether you need it)

A very nice feature to have on a relative cheap pedalboard system.

very convenient connection, replaces the junction box, there are enough inputs to connect the pedalboard through the input of the amplifier and through the fx loop at the same time. Build quality is good.

Pros:
Easy to set up and mount on my pedalboard.
Affordable unit
Connect all pedals and power unit to one block

Cons:
None

Very happy with my purchase! Thanks Thomann.

Great acquisition to my pedal board

Works really well and is great addition to my Rockboard. some of the plastic bits are a little loose.

It's a functionally great piece. However while installing, I couldn't directly screw the patchbay into the pebalboard, because the screw holes were not made to size of the screws. I'm not sure if they're deliberately small in order to have a tight fit. I had to use some tools to first enlarge the holes before the screws could get in.