Warwick Just A Nut III 5-string 45 mm

Of course i wanted gold one made of brass. But i have completely black Vampyre Sn. So here we go. Basically it resembles stock just-a-nut 2 that had unreliable side holder wings, that tend to brake. Version # 3 has this issue fixed.

There is also step-by-step replacement tutorial on youtube.

p.s. Doublecheck your bass nut width as it comes in two or three various dimensions.

Ahustable nut! Is anyone else is doing this?
Having the luxury of being able to adjust the nut height is just brilliant. I can tweak it to match different playing styles and don't have to worry about sanding it down to fit... The beauty is even if you did sand it down and went a little too far, you can quickly raise it back up. Lovely!

These Tedur Just a Nut IIIs are a great upgrade over standard plastic and bone nuts on most bass guitars. They are easy to instal and their design means you can set the nut height action very easily with a small allen key rather than hack away at your nut with a file!
If you change you string gauge in the future you can then just re-adjust the nut height rather than having to get the file out again.

Straight on and straight into action.
Not as bright sounding as the brass unit but that'll depend on your tone likes and needs.
Top notch... See that?

I bought it to replace an old bone nut in a 5 strings bass.
The concept is working well, just using the right alley wrench you will be able to set the right height directly, without filing it. Strongly reccomend it!

I bought this to replace a nut on my Warwick. I went with the plastic black one to match the rest of the black hardware.

Pros
- adjustable for treble and bass end, allows you to get the lowest possible action
- direct replacement for 45mm Warwick necks (the official guide can be found on Warwick youtube channel)


Cons
- a bit pricey for a plastic nut
- can pop up when changing strings, nothing but the strings are holding it down

Good upgrade of old or plastic nut.
+ better sustain than old nut
+ adjustable

This nut eliminates any need for a luthier. Having set of allen keys allows you to set up flat neck with lowest possible action under any conditions. If you change strings often and like your bass zing, klang and tap, look no further.

Easily fitted and a great repair or upgrade option. Go to the warwick site for precise fitting instructions and fitting tips

Ordered for a bass with a split nut. Fits perfectly, no defects.
Not much else to say really, Warwick stuff is always top-notch.