Adam Hall 3424TP Carry Handle

I recently inherited an old 2x12 combo guitar amp that had seen better day.

One of the main issues was the carry handle was falling apart and would hurt your hand if used.

This Adam Hall handle was almost an exact replacement for the old one. It mounted on perfectly to where the holes for the old handle were. Combined with a bit more TLC the amp in question now looks brand new again.

The handle looks great and feels very sturdy and strong whenever used.

Would Recommend.

Works, and super cheap!

Just what i needed!
Quality is top notch!
Came with fittings too :)

Needed to replace an old strap on a beaten up cab. Easy to install and use. Does the job well. It's not what I would put on an expensive cab or combo but this wasn't. So pleased.

A very basic carrying hand but few parts so little to go wrong. Inside the rubber exterior is a very strong metal flange which allows enough room to squeeze all four fingers underneath to lift something.

I used this on a 1x12 cabinet using M5 bolts for a secure hold. So far no bend of the metal and the rubber looks like it is made to last.

All in all very happy with the purchase. For a replacement handle, it is highly recommended.

I always buy parts from Adam Hall range. Very good quality, never let me down. This time to complete my 1x12 cabinet project. This handle is tough and nicely manufactured. I will definitely buy more of these in the future. You will not be disappointed

Bought this one for my 1x12 project cabinet. Works great, easy to install.
Little downside is that they dont send you the screws for it.
Spacing between screw centers is 21 Cm !

as it should be good and robust, used for my heave wooden pedal board which is natural colour.

The hardcase handle broke, this replacement is like the original. Recommend.