At first sight, they are quite presentable.
The soft holder fits all of my guitars, I'm not sure if a concert or wide nutted guitar would fit easily, but they work for me.
The positives are apprearance and build quality.
My negative issue is, the included mounting hardware will not work on stone or brick, so I had to find a different screw molly. OK, I loved the padded surface washer between the wall and plate. Once I got the plate mounted, the decorative plate went over the wall plate and the support arm could then be screwed into the plate. There is a decorative plastic sleeve that goes over the screw-in arm. I personally think this sleeve is at least 3mm too long as I had a difficult time getting the screw-in arm to even start. On one installation, Getting the arm started and getting at least two turns of threads into the plate, I pulled the mollys out of the wall and had to start over. I was more gentle with the next installation ( I bought three) and I still think I barely got the arm threaded into the mounting plate. I think at this point, I have two thinline guitars hanging on them, but I would never trust any of my electrics on them. I just don't think the arm screws in enough to ensure a safe support. The new molly/screw combination leaves me no doubt, but the screw in arm really needs to be able to screw in at least four or five turns before I would trust it. Possibly sanding the decorative sleeve down 3 or 4mm would give the arm more threads into the plate.
Hope this helps.
