To the page content

22.11 - 02.12

cyberweek-deal

Rean NYS 207

495

Jack

  • 2 Pole
  • Right angle
  • Height: 6.35 mm
  • Max. Cable diameter: 6 mm
  • Metal housing and plastic kink protection
  • Made by Rean (registered Trademark of Neutrik AG)
Available since February 2008
Item number 201815
Sales Unit 1 piece(s)
Installation No
Mono/Stereo Mono
Angled Yes
Type TS (mono/unsym.)
Plug Jack 6,3 mm TS male angled
4,20 AED 1,09 €
Plus 269 AED shipping
The price in AED is a guideline price only
Since we ship from Germany, additional costs through taxes and customs may be incurred
Quantity Discounts
Price each You save Quantity
4,20 AED 1
4,00 AED 4,8% 50
3,85 AED 8,3% 100
In stock
In stock

This product is in stock and can be shipped immediately.

Standard Delivery Times
1

495 Customer ratings

4.5 / 5

You have to be logged in to rate products.

Note: To prevent ratings from being based on hearsay, smattering or surreptitious advertising we only allow ratings from real users on our website, who have bought the equipment from us.

After logging in you will also find all items you can rate under rate products in the customer centre.

quality

177 Reviews

AM
Buy this if You need angle connector 6.3mm
Alexandr Mardari 11.05.2021
Buy this if You need angle connector 6.3mm.
I used such designed angled connector named with different brands.
It was always good, never broken. It looks not beautiful, but it is more sturdy than every another design connector in compare. Just does it job well and fits from thin to thick cables. I always use many circles of duct tape above cable attachment point using thin cables, after it is impossible to break the junction.
quality
0
0
Report

Report

A
Neutrik Quality made in China
Anonymous 21.07.2014
I have used these plugs for several years now, soldering my own cables for my effects board and making instrument cables. The quality of these plugs is absolutely outstanding for this cheap price. I can hear or see no difference between these plugs and more expensive ones.

The only tricky part is soldering the mass contact to the plug, but with a little bit of excercise (probably after two or three cables), you will do just fine and have good, long lasting plugs for your instruments and effects for barely one euro.

You have to be careful though when using these plugs directly into your amplifier, because of the angled jack it sometims blocks other inputs (for example on my Laney IRT Studio)
quality
0
0
Report

Report

A
Anonymous 11.06.2015
Very high quality for a cheap plug. Also very easy to solder, does not need a large amount of heat. The plastic looks weak, but it actualy is not. I have soldered on hundreds of them already onto the cables I make with no complaints. They easily over-last the cables they are soldered on. Highly recommended!!!
quality
0
0
Report

Report

f
Very reliable
flivver 08.12.2017
If you need angled jack connector, this one is absolutely acceptable. Easy to solder, easy to assemble. So far very reliable.
quality
0
0
Report

Report